Tool changer for ISEL UFM 1050

The attachment is screwed onto the spindle shaft and fixed to the spindle. Afterwards the tool change spindle can be easily attached to the 43 mm Euro-neck like the original ISEL.

function:

The tool sits in a SK15 tool holder with an ER11 collet. This is held in the taper by spring force with a collet. A pneumatic cylinder presses on this collet during tool change, releases the tool from the taper and releases it.

Technical data:

• Anodized aluminum housing 7075
• Spindle shaft made of stainless steel, double ball bearing
• Circulation accuracy 0.02 mm
• Finely balanced
• Weight 0.8 kg
• Tensile force of the spring 25 kg = approx. 250N
• Uses SK15 tool holders for ER11 collets (1-8 mm)
• Operating pressure 8 bar
• 2 pneumatic connections for 6 mm hoses
• Fastening with 43 mm Euro-neck
• For speeds up to 28. 000 rpm suitable
• Increase of the spindle by this attachment: 55 mm
• Diameter of the attachment: 59 mm
• Matching for ISEL UFM 1050 and identical spindles

Scope of delivery:

Tool change attachment suitable for ISEL UFM 1050 incl. 2 SK15 ER11- holders and short instructions. The illustrated ISEL spindle is not included in the scope of delivery! To operate this tool changer, you need a device to control the compressed air for the change function.